ALLEN & HEATH GL3300 User's Guide download pdf (Page 19)

GL3300 USER GUIDE

INTERNAL LINK OPTIONS

The console is set to satisfy most applications that should be encountered. However, the following internal

link options are offered to provide alternative settings for those applications that may require them. These

options involve resoldering of circuit board links and should only be carried out by competent technical

personnel. Further information is available in the GL3300 SERVICE MANUAL and from your agent.

MONO INPUT

1. Reconfigure each aux as required to be

permanently pre-fade or post-fade rather than

switched by the front panel PRE/POST switch.

2. Reconfigure the pre-fade sends to be post-

EQ / pre-mute, or pre-EQ / post-mute, instead

of the standard post-EQ / post-mute.

3. Disable +48V phantom power regardless

of panel switch position - remove link.

4. Reconfigure Direct Out to be pre-fader

instead of post fader.

STEREO INPUT

1. Reconfigure each aux as required to be

permanently pre-fade or post-fade rather than

switched by the front panel PRE/POST switch.

2. Reconfigure the pre-fade sends to be post-

EQ / pre-mute, or pre-EQ / post-mute, instead

of the standard post-EQ / post-mute.

3. Disable +48V phantom power regardless

of panel switch position - remove link.

LEFT

1. Reconfigure the LR sum source (mono)

from post LR faders to pre faders.

2. Enable +48V phantom power to talkback

mic input - fit link.

GROUP

1. Fit Matrix out balance option for jack

output tip = hot, ring = cold. Remove two links

and plug in balance driver IC.

2. Reconfigure the feed to the optional VU

meterpod to follow the aux master rotary control

rather than the group fader - remove two resistors

and link two pairs of pads with a length of wire.

1 2 ... 14 15 16 17 18 19 20

No comments

ALLEN & HEATH GL3300 User's Guide Page 19