ALLEN & HEATH WZ20S User's Guide download pdf (Page 16)

16 WZ20S User Guide

Connecting Auxiliary Outputs

AUX6AUX AUXAUX5 4

SENDS

23 AUX AUX1

AUX 1-6 OUTPUTS Each of the six auxiliary sends is available on a 3 pole TRS jack

socket. These are impedance balanced to reduce noise pickup on long cable runs.

Connect to balanced or unbalanced equipment as shown above. Nominal operating level

is –2dBu but gain is available using the send master control to drive +4dBu if required.

Use pre-fade auxes to feed stage monitor, foldback and cue systems. Use post-fade

auxes to feed effects processors such as reverb, and to provide independent zone,

cleanfeed and recording feeds.

Connecting the Headphones and Local Monitor

TIP = L

RING = R

LOCAL MONITOR OUTPUTS A pair of 3 pole TRS jack sockets provide left and right

outputs from the console local monitor system. These are impedance balanced and can

be connected to balanced or unbalanced equipment as shown above. Nominal operating

level is –2dBu but gain is available to drive +4dBu if required. Independent control is

provided for the local and the headphones monitor systems.

HEADPHONES 2 OUTPUT Two outputs are available for stereo headphones, one on

the front panel, the other on the rear panel. This is convenient for permanent installation

or when two headphones are required at the same time, for example presenter and guest

in a broadcast application. The same signal is available from both. Headphones are

available in many different styles, impedances and volume ratings. To get the best from

your system we recommend that you use high quality closed ear headphones in the

range 30 to 600 ohms. 8 Ohm headphones are not recommended.

WARNING Some headphones are more sensitive than others and can

produce higher output levels. To avoid damage to your hearing start with the

PHONES level control at minimum and turn up only as much as is needed to

maintain comfortable listening level. Do not drive headphones at high listening

levels for long periods of time.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 34 35

No comments

ALLEN & HEATH WZ20S User's Guide Page 16