ALLEN & HEATH GS-R24 User's Guide download pdf (Page 10)

Allen & Heath 10 GS_R24 FireWire/ADAT Module User Guide

MODULE FITTING INSTRUCTIONS

Beware of ESD! Observe anti-static handling precautions—avoid touching the electronic devices on

the circuit board, ensure any static build up is discharged to earth before handling the module.

This can be achieved by ensuring the console is connected to the psu and the psu is plugged in to a

mains outlet but switched OFF, then touching a metal part of the console panel such as a screw head.

Remove 2 x screws

Remove the blanking panel at the

rear of the console by removing

the two screws.

Locate the module circuit board

in the plastic guide slots within

the housing.

Slide the module into the housing

and push firmly to insert the

module connectors into the con-

sole connector sockets.

Re-fit the fixing screws at either

end of the module panel.

Push

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 19 20

No comments

ALLEN & HEATH GS-R24 User's Guide Page 10