ALLEN & HEATH XONE:23C User's Guide download pdf (Page 19)

REPLACEMENT PARTS Reconfiguring the soundcard for use with DVS

To reconfigure the mixer to work with DVS software you need to

route the audio signals from the turntable pre-amplifiers directly to the

soundcard using the short three-way harnesses supplied with the mixer.

Referring to page 18, undo the screws securing the top panel to the

chassis and carefully lift up the panel to gain access.

The three-way harnesses plug into sockets located underneath the top

PCB, and are then plugged into sockets located on the soundcard PCB,

as shown in the picture below.

The harness from the left side of the top PCB plugs into the right hand

side socket on the soundcard PCB.

The sockets are keyed and will only plug in one way, and will click into

place securely.

Ensure that the harnesses will not get trapped between the chassis and

top panel, and carefully reassemble the mixer.

Refer to the MixVibes documentation on how to configure the soft-

ware to use encoded vinyl.

The sockets are keyed and will only plug in one

way - ensure they are correctly orientated before

pushing them home!

The default routing for the soundcard sends (to the computer) is for USB channel 1-2 = record output and USB 3-4 = FX send.

This configuration allows you to record your set and add FX (see hints and tips on page 21).

The supplied software, MixVibes Cross LE, can also be used with time-coded vinyl and to use this option the mixer soundcard

routing will need to be internally reconfigured.

This job should be entrusted to an authorised service agent whilst the mixer is still under warranty

as any damage due to incorrect procedure will not be covered.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 25 26 27

No comments

ALLEN & HEATH XONE:23C User's Guide Page 19