ALLEN & HEATH iLIVE User's Guide download pdf (Page 33)

iLive Fixed Format Getting Started Guide 33 AP7141 iss.6b

Refit 5x M4 x 8mm screws

12U 13U

M6 x 16mm SLOT screw

part AB0344

M6 cup washer

part AB0345

Remove 8x M4 x 8mm TORX screws

Use T20 driver

M4 x 8mm TORX screw

part AB0332

563mm (22.2") to rear of pod

from front of rack rail 533.4mm (21") 12U rail

578mm (22.75") 13U rail

217mm (8.54")

131mm (5.16")

230mm (9.06")

193mm (7.6")

47.5mm (1.87")

from front of rack rail

470mm (18.5")

485.5mm (19.1")

513mm (20.2")

540.5mm (21,3")

52.5mm (2.07")

120.7mm (4.75")

237mm (9.33")

172mm (6.77")

482.2mm (19")

from front of trim

368mm (14.5")

540mm (21.26")

To fit rack ears

Store remaining screws

471.4mm (18.56") with side trims fitted

36.8mm (1.45")

1mm to end of 12U rail

190.6mm (7.5")

C

133.3mm (5.25")

133.3mm (5.25")

482mm (19") with rack ears fitted

Rack Mounted

Desk Top

5mm to end of rail

33mm (1.3")

Rack Ears - Flush Mounted

Rack Ears - Angled

16 degrees

Desk Top - Side Trims Fitted

1

2

3

2

3

Dimensions

iLive-R72 Rack Ears - Fitting Instructions

The iLive-R72 Surface can be configured for

desk top, flight case, 19” rack or furniture

installation. The plastic side trims can be

removed and replaced with the metal rack

ears provided. A minimum 12U rack space is

needed. More may be needed depending on

connector access requirements.

Two rack ear positions are available – either

flush with the control panel or angled at 16

degrees for a lower profile fit.

When rack mounting ensure adequate

ventilation and space for the connectors,

cables and lamp fitting at the rear.

Note – Due to the height of the TouchScreen

a rack case with a deep lid is required. Many

standard off-the-shelf equipment cases are not

intended for consoles such as the iLive.

However, most flight case manufacturers can

provide custom cases to suit different mixer

models.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 39 40

Comments to this Manuals

No comments