ALLEN & HEATH GL 2000 User's Guide download pdf (Page 6)

GL2200 USER GUIDE

CONNECTING POWER TO THE CONSOLE

Refer to the SAFETY WARNING on page 4 of this User Guide. Read and understand the warnings

and instructions printed on the rear panel of the console and printed here.

The GL2200 console can be powered from either the internal power supply, from an external

DC supply such as the Allen & Heath RPS11, or both together. The LED indicators on the rear

panel illuminate to indicate which supply is active.

Normally the internal power supply will be used to power the console by the standard 3 pin IEC

mains input connector. A mains cable with moulded mains plug suitable for the local supply is

supplied. Check that the correct mains lead with moulded plug has been supplied with your

console. Ensure that the IEC mains plug is fully inserted into the rear panel socket before

switching on.

POWER SUPPLY

The internal power supply for the GL2200 is a switch mode supply and will operate from a wide

range of mains input voltages. It produces the DC voltages required by the console. Before

switching on your console, check that the ac mains fuse is of the correct type and rating. This is

clearly marked on the rear panel of the console. Do not replace the fuse with any other type, as

this could become a safety hazard and will void the warranty.

AC~ mains input voltage Fuse value

100 - 230V ±10% T 1A 250V 20mm

DO NOT O

SEE INST

WARNING: TO REDUC

T1A 250V 20mm

WARNING - THIS APPARATUS MUST BE EARTHED.

EXTERNAL SUPPLY INTERNAL SUPPLY

ACTIVE ACTIVE

100 - 240V~

100 - 240V.AC

47-63Hz ~ 60W MAX

SUPPLY VOLTAGE RANGE:

NO USER

WARNING: DISCONNECT SUPPLY BEFORE CHANGING FUSE.

ATTENTION: COUPER L'ALIMENTATION AVANT DE CHANGER LE FUSIBLE.

CAUTION: FOR CONTINUED PROTECTION AGAINST RISK OF FIRE REPLACE FUSE

ATTENTION: REMPLACER LE FUSIBLE AVEC UN DES MEMES CARACTERISTIQUES.

WITH SAME TYPE AND RATING.

Ensure adequate ventilation around the console. Do not cover the

console or position it on soft furnishin

s durin

operation.

The console must be connected to 0V ground by either the a.c.

mains input cable or by the EXTERNAL DC IN cable.

CAUTION: For continued protection against the risk of fire, replace

fuse onl

with the correct t

e and value.

The console power supply unit contains no user serviceable parts.

Do not remove the cover. Refer servicing to qualified service

personnel only.

1 2 3 4 5 6 7 8 9 10 11 ... 27 28

Comments to this Manuals

No comments

ALLEN & HEATH GL 2000 User's Guide Page 6

Comments to this Manuals

Related products and manuals for Audio mixers ALLEN & HEATH GL 2000