ALLEN & HEATH ME U User's Guide download pdf (Page 14)

User Guide – AP9209_2 14 ALLEN&HEATH

8.5 System Setup page

Use this page to access ME-U system

settings:

ME-U IP Settings – Displays the current

network static TCP/IP settings. You can

change these if you wish to access the ME-U

via a different network.

Default settings can be restored using the

front panel recessed ‘Reset’ switch.

IP address = 192.168.1.40

Subnet Mask = 255.255.255.0

Default Gateway = 192.168.1.254

 If you are using the Network port to

receive names from an iLive system then

make sure the ME-U and iLive network

addresses are compatible.

 If you are not sure how to set these

settings then refer to your IT administrator.

Host MAC Address – This is the permanent

address assigned to the ME-U hardware.

dSNAKE MAC Address – This is the

permanent address assigned to the input

card found in the Input Port.

Source Mode – If you are using ME-U with an

iLive system and connecting its network to

receive its names and stereo link status then

tick the iLive mode box.

 If you are not connecting to an iLive

system then make sure the box is not

ticked. Failure to do so may result in the

ME-U being unable to find names from the

connected system.

iDR Mix Rack Selection – The ‘Found Units’

list shows any iDR racks found on the

network. Choose the rack to connect to.

The ‘iDR Mix Rack’ box shows the name of

the iLive iDR rack the ME-U looks for when

starting.

This setting is only used if iLive Source Mode

has been selected.

Default - Restores the factory default iDR Mix

Rack name.

If you make changes to the settings click

‘Save’ to confirm or ‘Cancel’ to restore the

previous settings.

1 2 ... 9 10 11 12 13 14 15 16 17 18

Comments to this Manuals

No comments