ALLEN & HEATH ME U User's Guide download pdf (Page 6)

User Guide – AP9209_2 6 ALLEN&HEATH

3. Front Panel

4. Rear Panel

`

Main Input - IEC connector, fuse and

ON/OFF push switch for the built-in

universal voltage power supply unit.

This accepts worldwide voltages from

100 to 240V AC 50/60Hz. Check that

you have received the correct mains

lead for your territory.

Input Port – To receive sources to

distribute to ME-1 personal mixers. The

ME-D input card is provided as standard

and works with any dSNAKE, ACE, Aviom

®

A-Net16 source. Several other option cards

are available from Allen & Heath letting you

interface the ME-U to other mixing systems:

Dante, MADI, Waves SoundGrid,

EtherSound.

 The ME-U input works with 48kHz 24-bit

audio only.

10 Output Ports – To distribute audio and

power to up to 10 ME-1 personal mixers. Can

also connect to the input of another ME-U hub

when connecting to more than 10 ME-1 mixers.

Each port provides:

 40 channels of audio

 Channel names

 Channel stereo linking

 Power for the ME-1 mixer (PoE)

 Locking EtherCon connection

 The ME-U outputs are compatible with the

Allen & Heath ME system only.

An indicator next to each port

lights yellow to show it is linked

to its connection, and flashes to

show network activity. It lights

red during start up or when an

error is detected.

Network Reset – A

recessed switch for power

up reset of the ME-U

network address to

factory default.

Network Port – To connect a PC or Mac

computer for system setup and channel naming.

 Use the mains lead for your territory as

supplied with the ME-U.

 Secure the mains lead using the plastic clip to

prevent it being pulled out.

 Heed all the warnings printed in the Safety

Instruction sheet and on the rear panel.

 To ensure adequate cooling do not obstruct

the ventilation slots.

ME-D standard input card.

The Lnk/Act indicator flashes

when working with ACE or

dSNAKE. It stays on when

working with Aviom

®

.

1 2 3 4 5 6 7 8 9 10 11 ... 17 18

Comments to this Manuals

No comments