ALLEN & HEATH ZED436 User's Guide download pdf (Page 32)

Allen & Heath 32 ZED-4 BUS User Guide

USING USB FOR EFFECTS

Use post fade Aux 5 & 6 as the sends from ZED so when you move the channel

fader the effects level stays in proportion.

Select Aux 5-6 on the USB output selector switches.

USB lead carries the digital signals to & from the computer.

Select USB Device Left for Aux 3 or Right for Aux 4 as the input for the track in

the software package.

You can use a send bus in software as you would a hardware mixer.

Assign an effect from your software plug-in list.

If using reverb, it’s a good idea to have 100% wet mix level and reduce the pre-

delay in order to compensate for any latency in USB.

Send the output of the software group or bus to USB Device. In this case, and

probably with most reverbs, it will be stereo so it will go to left & right.

Set the USB return to be sent to ST3. It can then be sent directly to LR or to the

stereo channel by pressing in the under-panel switch below the ST3 Level control.

USB

SENDRETURN

MTX

1-2

AUX

1-2

AUX

5-6

pre-fade

All up =LR post

PLAYBACK

To LR

ALLEN&HEATH

USB

2TRK

PLAYBACK SOURCE

LEVEL

PLAYBACK

PFL

USB SEND SOURCE

ST3 INPUT SOURCE

USB

ST3 IN

AUX5

POST

AUX6

POST

PRE

POST

1 2 ... 27 28 29 30 31 32 33 34 35 36

Comments to this Manuals

No comments

ALLEN & HEATH ZED436 User's Guide Page 32

Comments to this Manuals

Related products and manuals for Audio mixers ALLEN & HEATH ZED436